Setting Fanspeed; Factory Reset - Jaga VERTIGA HYBRID Manuel

7.2. SETTING FANSPEED
1. Put the device in the mode that you want to adjust :
2. Put the device in the speed that you want to adjust :
3. Short press [-] or [+] to adjust the set speed
1
-
The blue LED
the minimum speed is reached
SPEED %
50 55 60 65
4. After 30 seconds, the new settings are automatically saved and the device returns to the selected
mode.
7.3. FACTORY RESET
1. Disable power charge .
2. Press and hold down both the [-] and [+] button on the circuit board
and switch on the power again. The
by the green LED 2 seconds later and the
Release the buttons as soon as all 3 LEDs are flashing .
3. The controller will return to the Factory settings, all LEDs will flash for 10 seconds. The controller
will return to the Factory Default settings, all LEDs will flash for 8 seconds .
JAGA NV | VERTIGA HYBRID | MANUEL | 29 NOVEMBER 2021, 11:15 | V.01
flashes quickly as soon as The red LED
. the maximum speed is reached.
70 75 80 85
blue LED will light up, followed
red LED
Cooling / Heating
flashes quickly as soon as
90 95 100 105
1
4 seconds later.
1
-
110 115 120
-
49
EN