Control / Operation; Settings Via Circuit Board Controller; Setting Fanspeed - Jaga CLIMA CANAL HYBRID H8 Manuel D'installation Et D'utilisation

6. CONTROL / OPERATION
The user must manually switch between heating and cooling.
Press and hold to switch modes (± 3 sec ).
3"
Off
Cooling : If the water temperature < 18 ̊ C , the fan will start to spin.
Heating : If the water temperature > 28 ̊ C , the fan will start to spin.
The water temperature is measured on the heat exchanger.
Manually changing the fan speed : short press
Speed 1
Red LEDs are flashing: the water temperature for heating is too low (< 28 ̊ C ).
Blue LEDs are flashing: the water temperature for cooling is too high (> 18 ̊ C ).
7. SETTINGS VIA CIRCUIT BOARD CONTROLLER
7.1. SETTING FANSPEED
1. Select the mode that you want to adjust : Cooling / Heating
2. Select the speed that you want to adjust : Speed 1
3. Short press [-] or [+] to adjust the preset speed .
INPUT: 110-240VAC
CO2
OUTPUT: 24V
PC / RF
N L
4. After 30 seconds, the new settings are automatically saved and the device returns to the selected
mode.
JAGA N.V. | CLIMA CANAL PLUG & PLAY | MANUEL | 2021.05.03 | V.01
Heating
(6V)
(4V)
Speed 2
The blue LED flashes quickly when the minimum speed
is reached .
The red LED flashes quickly when the maximum speed
is reached.
Off
(8V)
(6V)
/ Speed 2 / Speed 3
Cooling
(10V)
(10V)
EN
Speed 3
INPUT: 110-240VAC
CO2
OUTPUT: 24V
PC / RF
N L
51