Settings; Adjusting The Water Temperature - Jaga VERTIGA HYBRID Manuel

7. SETTINGS
7.1. ADJUSTING THE WATER TEMPERATURE
7.1.1. Setting the maximum water temperature for cooling
By setting the temperature lower, the unit will start later. If the water temperature is set higher, the unit
will start faster .
1. Start setup mode: hold the [-] button until the
2. Briefly press the [-] or [+] button to adjust the set temperature .
1
-
The blue LED flashes quickly as soon as the
minimum temperature is reached.
Automatic control: The
set temperature
3. Exit setup mode: hold the [-] button until the
7.1.2. set minimum water temperature heating
By setting the temperature higher, the unit will start later. If the water temperature is set lower, the
unit will start faster .
When using a heat pump, it may be necessary to set the water temperature at a lower setting .
1. Exit setup mode: hold the [+] button until the
2. Briefly press the [-] or [+] button to adjust the set temperature .
1
-
The blue LED flashes quickly as soon as the minimum
temperature is reached.
Automatic control: The
temperature .
3. Exit setup mode: hold the [+] button until the
After 30 seconds, the new settings are automatically saved and the device returns to the
selected mode.
48 JAGA NV | VERTIGA HYBRID | MANUEL | 29 NOVEMBER 2021, 11:15 | V.01
12 ̊ C 14 ̊ C 16 ̊ C 18 ̊ C
green LED lights up when the water temperature (supply water) is lower than the
24 ̊ C 26 ̊ C 28 ̊ C 30 ̊ C
green LED lights when the water temperature (supply water) exceeds the set
blue LED flashes 5x and release .
20 ̊ C 22 ̊ C 24 ̊ C
The red LED flashes quickly as soon as the maximum
blue LED flashes 5x and release .
red LED flashes 5x and release .
32 ̊ C 34 ̊ C 36 ̊ C
The red LED flashes quickly as soon as the maxi-
mum temperature is reached.
red LED flashes 5x and release .
1
-
26 ̊ C
temperature is reached.
1
-
38 ̊ C