Important Notes; Applications; Conformity And Approval; Operation - Monacor International JTS UF-10TB/12 Mode D'emploi

2 Important Notes

The unit corresponds to all relevant directives of
the EU and is therefore marked with
G
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high air
humidity and heat (admissible ambient tempera-
ture range: 0 – 40 °C).
G
For cleaning only use a dry, soft cloth; never use
water or chemicals.
G
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it is not
correctly operated, or if it is not repaired in an
expert way.
If the unit is to be put out of operation
definitively, take it to a local recycling plant
for a disposal which is not harmful to the
environment.

3 Applications

Combined with the JTS receiver UF-10R /12, the
pocket transmitter UF-10TB /12 creates a wireless
audio transmission system. The REMOSET func-
tion is a most convenient feature for operating the
system: Simply press a button and, via a 2.4 GHz
radio signal, the pocket transmitter is matched to the
transmission frequency selected on the receiver.
The pocket transmitter is supplied with the lava-
lier microphone CM-501. Instead of the CM-501, all
JTS headband microphones and instrument micro-
phones with a 4-pole mini XLR plug can be used
(designation: CM-... and CX-...).

3.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare
that the pocket transmitter UF-10TB /12 is in accord -
ance with the basic requirements and the other rel-
evant regulations of the directive 1999/5/EC. The
declaration of conformity can be found on the Inter-
net:
www.jts-germany.de or www.monacor.com
This pocket transmitter may be operated in the fol-
lowing countries:
DE
In the Federal Republic of Germany, the pocket
transmitter UF-10TB /12 requires a frequency as -
signment (for which a fee is charged).
In other countries, it is necessary to apply for a cor-
responding approval. Prior to operating the system
outside Germany, please contact the MONACOR
.
subsidiary or the corresponding authorities of the
respective country. Links to the national authorities
can be found via the following Internet address:
www.cept.org
→ ECC
→ Topics
→ Short Range Devices (SRD) and other R&T TE
sub-classes
→ EFIS and National Frequency Tables

4 Operation

4.1 Inserting / Replacing the batteries

For power supply, two 1.5 V batteries of size AA are
required.
G
Only insert batteries of the same type and always
replace both of them.
G
If the microphone is not in use for a longer period
of time, always remove the batteries to prevent
damage due to battery leakage.
1) Push down the latch (5) to open the battery
compartment cover (6).
2) Insert the batteries with the positive and nega-
tive poles as indicated in the battery compart-
ment.
3) Close the battery compartment cover so that it
is locked.
4.2 Connecting the microphone and
fastening the transmitter
1) Connect the supplied lavalier microphone to the
mini XLR jack (8) and use the clip to fasten it on
your clothes (e. g. tie or lapel). Alternatively, use
another suitable JTS microphone (
ter 3).
2) When all settings have been made on the trans-
mitter, use the clip on the back of the transmitter
to fasten it on your clothes (e. g. belt or waist-
band).
Never put used batteries in the household
waste; always take them to a special
waste disposal, e. g. collection container at
your retailer.
chap-
11