Important Notes; Applications; Conformity And Approval; Operation - Monacor International JTS UF-20TB/5 Mode D'emploi

Pocket Transmitter for
Audio Transmission
These instructions are intended for users without
any specific technical knowledge Please read
the instructions carefully prior to operation and
keep them for later reference

1 Important Notes

The unit corresponds to all relevant directives of
the EU and is therefore marked with
•
The unit is suitable for indoor use only Protect
it against dripping water and splash water,
high air humidity and heat (admissible ambi-
ent temperature range: 0 – 40 °C)
•
For cleaning only use a dry, soft cloth; never
use water or chemicals
•
No guarantee claims for the unit and no li-
ability for any resulting personal damage or
material damage will be accepted if the unit
is used for other purposes than originally in-
tended, if it is not correctly operated, or if it
is not repaired in an expert way
If the unit is to be put out of operation
definitely, dispose of the unit in accord-
ance with local regulations

2 Applications

Combined with the JTS receiver UF-20R / 5 or
UF-20S / 5, the pocket transmitter UF-20TB / 5
creates a wireless audio transmission system
The REMOSET function is a most convenient
®
feature for operating the system: Simply press
a button and, via a 2 4 GHz radio signal, the
pocket transmitter is matched to the transmis-
sion frequency selected on the receiver
For audio transmission, a microphone is
required A wide range of microphones is avail-
able from JTS: All microphones with a 4-pole
mini XLR plug are suitable

2.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare
that the product UF-20TB / 5 complies with the
directive 2014 / 53 / EU The EU declaration of
conformity is available on the Internet:
www jts-europe com
Restrictions or requirements apply in the
following countries:
CZ
IT
The regulations of the country where the prod-
uct is operated must always be observed Prior
to operating the product, please contact the
MONACOR subsidiary or the corresponding
authorities of the respective country Links to
the national authorities can be found via the
following Internet address:
www cept org
ECC
Topics
Other spectrum topics: SRD Regulations and
indicative list of equipment sub-classes
EFIS and National Frequency Tables

3 Operation

3.1 Inserting or replacing the batteries
For power supply, two 1 5 V batteries of size
AA are required If the LED
batteries are discharged and should be replaced
•
Only insert batteries of the same type and
always replace both of them
•
If the transmitter is not in use for a longer
period of time, always remove the batteries
as a precaution to prevent damage due to
battery leakage
1) Push down the unlock button (6) to open the
battery compartment cover (7)
2) Insert the batteries with the positive and
negative poles as indicated in the battery
compartment
3) Close the battery compartment cover so that
it is locked
3.2 Operation with
rechargeable batteries
Instead of non-rechargeable batteries it is
also possible to insert two rechargeable NiMH
(nickel- metal hydrate) batteries of size AA To
charge these batteries, the charging station
CH-2 is ideally suited: Leave the batteries in the
pocket transmitter and insert the transmitter
EL FI FR
LT MT PL
(2) shows red, the
13