RDI AVALON Mode D'emploi page 7

12.
Starting at one end of your installation, fi t your
end cover onto the top rail and place down
so that the end cover and top rail fi t onto your
post bracket and rail panel (Fig. 17). Dry fi t
your top rails in place moving from one post
to the next. For corner applications, once one
end of your corner is dry fi t in place, you may
have to angle your top rail down into the other
side of the corner cover (Fig. 18). Working
from one end of your installation to the other
end, fi t your top rails into place ensuring the
top rail fi ts snugly into the bracket covers and
onto the rail panels.
13.
Using the holes in the bracket as a guide,
pre-drill two ¹⁄ " holes from under the bottom
8
of the rail up through the top rail as shown in
Figure 19. Drive two screws (F) up through
the hole locking the bracket, panel, and top
rail together, being careful not to drill through
the top of the top rail (circled with dotted line).
Fig. 17
Fig. 18
14.
If using any standard posts, install pyramid
post top onto each post. Note: A rubber
mallet may be needed for proper fi t.
Fig. 19
7