RDI AVALON Mode D'emploi page 5

7.
STANDARD POSTS
For any standard (non-over-the-top) posts
in your installation, open the paper bracket
mounting template (included with brackets
in the rail panel), align base trim with
appropriate guide on template, and secure
template in place using a piece of tape. Pre-
drill through the desired marked locations
1
on the template using a / " drill bit. Remove
8
template, align brackets (Fig. 10) with the
holes ensuring that brackets are square,
and fasten brackets in place using the 1 ½"
screws provided.
Test fi t rail panel. Once proper fi t is ensured,
press bottom bracket covers onto the ends
of your bottom rail, and set panel in place in
brackets.
Top Level Bracket Bottom Level Bracket
8.
Pivot support foot (D) in place under the rail
as shown (Fig. 11). (Note: if using a section
longer than six feet, use two support feet
(included with 8' panels) and distribute evenly
along the length of the panel). Secure support
foot/feet to the mounting surface using the
screws provided (E) and press fi t cover into
place using plastic plug(s) as shown (Fig.12
& 13).
A.
Fig. 10
Fig. 11
Fig. 12
B.
Fig. 13
5