R&G RSET018BK Mode D'emploi page 5

Page | 5
BRAKE SIDE

Undo and remove the two bolts holding the heel guard and master cylinder as arrowed in
picture 5.

Undo and remove the two bolts holding the original footrest to frame while supporting the
footrest as shown in picture 6.

Unclip the spring and remove the original brake light sensor as arrowed in picture 7.

Disconnect the master cylinder connector arrowed in picture 8 and replace with the female
ball joint as shown in picture 9.
Remove the footpeg and ZX6R '07-'08 lever from the R&G rearset and replace it with the

alternative lever (supplied) and reassemble and tighten. (Item #16) – (the lever's tail should
angle downward for '07-'08 and upwards for '09-)

Fit the gear shift assembly into position using the two bolts and spacers as shown in picture
10.

Connect the ball joint and gear shift lever using the spacer as shown in picture 11 (please
ensure to use the nyloc nut to secure).

Secure the master cylinder using the two bolts as arrowed in picture 12 (please ensure the
master cylinder pressure shaft is directly in line with master cylinder as shown in picture 12.

PLEASE NOTE FAILURE TO DO THIS MAY RESULT IN BRAKE FAILURE
AND/OR JAMMING OF BRAKES. Ensure the rearsets have the correct bracket for your
model of bike – For Kawasaki ZX6R '07-'08 use item #13. For Kawasaki ZX6R '09- use item
#9
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
PICTURE 11
PICTURE 13
2009-2013
ON NON ABS MODELS
R&G Racing
PICTURE 12
www.rg-racing.com Email: info@rg-racing.com