Care And Cleaning - KitchenAid KSB8270 Mode D'emploi

CARE AND CLEANING

NOTE: To avoid damaging the Blender, do not immerse the blender base or cord in
water. To avoid scratching, do not use abrasive cleansers or scouring pads.
1
Unplug the Blender. Empty the blender jar. Fill half of the jar with water and add 3-4 drops
of liquid dish-washing detergent. Place the Blender jar with Lid on the blender base.
Rotate the control dial to "
ends, pour out the soapy water, and rinse the blender jar with warm water.
2
Unplug the Blender before cleaning. Wipe the Base and the cord with a warm, damp cloth
and dry with a soft cloth.
Dishwasher-safe parts, top rack only: Lid, Tamper, and Ingredient-measuring cap.
Dishwasher-safe parts, bottom rack only: Blender Jar.
All parts may also be washed by hand with warm soapy water, and then rinsed with warm
water and dried with a soft cloth.
SANITIZING THE BLENDER
1. Empty the blender jar.
2. Prepare a 200 ppm sodium hypochlorite
solution* using 1.75 L of hot water in the
blender jar. Place the lid on the blender
jar, and make sure the blender jar is fully
in place on the blender base.
3. Run the Blender on the High Speed
setting for 35 seconds.
Flip the Start/Stop up or down to start
the Blender.
4. Turn off the Blender and let the sanitizing
*To prepare a 200 ppm sodium hypochlorite solution: use 6.67 ml household bleach
(with a 5.25% sodium hypochlorite concentration) in 1.75 L of hot water.
For detailed information:
Visit www.kitchenaid.com/quickstart for additional instructions with videos, inspiring
recipes, and tips on how to use and clean your Stand Blender.
8
W11383480B.indb 8
6
5
4
3
2
1
0
". Flip the Start/Stop up or down to start. When the cycle
mix sit in the blender jar for an additional
2 minutes.
5. Pour out the sanitizing solution mix. Do
not rinse the blender jar.
6. Place the lid on the blender jar. Make sure
the empty blender jar is fully in place on
the blender base. Run the empty Blender
for an additional 10 seconds. Do not rinse
the jar after sanitizing.
7. Allow the blender jar to air dry.
7
8
9
10
11
11/18/2019 6:56:22 PM