Care And Cleaning - KitchenAid ARTISAN 5KSB555 Mode D'emploi

Masquer les pouces Voir aussi pour ARTISAN 5KSB555:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 37
The Blender pitcher, locking collar and
blade assembly can be easily cleaned as
individual components or together without
disassembly.
• Clean the Blender thoroughly after
every use
• Do not immerse the Blender base or
cord in water
• Do not use abrasive cleansers or
scouring pads
To Clean Individual Components
1. Lift the pitcher assembly in a straight,
upwards motion off the Blender base.
Place jar assembly on a hard surface.
Then, while holding locking collar,
rotate pitcher counterclockwise, two
clicks, to separate locking collar and
blade assembly, and sealing ring from
the pitcher. Wash components with
soapy water. Rinse and wipe dry.
NOTE: Pitcher can be placed in the
bottom rack of an automatic dishwasher.
For best results, hand washing is
recommended for the lid, ingredient cup,
locking collar and blade assembly, and
sealing ring.
Pitcher
Sealing
Ring
Locking
Collar
and Blade
Assembly
2. Wipe the Blender base and cord with
a warm, sudsy cloth; wipe clean with a
damp cloth, and dry with a soft cloth.

Care and Cleaning

To Clean Without Disassembly
2. To clean the lid and ingredient cup,
3. Wipe the Blender base and cord with
10
1. Put the pitcher on the Blender base,
fill half full with warm (not hot) water,
and add 1 or 2 drops of dishwashing
liquid. Put the lid on the pitcher, press
the STIR speed setting, and run the
Blender for 5 to 10 seconds. Remove
the pitcher and empty contents. Rinse
with warm water until clean.
wash in warm soapy water, then rinse
and dry thoroughly.
a warm, sudsy cloth; wipe clean with a
damp cloth, and dry with a soft cloth.

Publicité

Table des Matières
loading

Table des Matières