Honeywell Miller Vi-Go Automatic Manuel D'utilisation page 7

Installing the Vi-Go Automatic Cable Sleeve
to Vertical Cable Lifeline
The unique design of the Vi-Go Automatic Cable Sleeve permits one-hand installation
to the lifeline, while an anti-inversion mechanism prevents the cable sleeve from being
installed upside-down on the cable.
Swivel Carabiner
1. While pushing upward on the underside of the
shock absorber with your thumb, press the lock knob with your index finger.
2. With the lock knob pressed, push the slider into the casing.
3. Through the now-open cable channel gap, place the cable sleeve
on the cable such that the arrow on the casing points upward.
4. Release the slider and the lock knob. IMPORTANT: Ensure that the cable channel
closes completely [maximum of 1/4" (6.35mm) gap].
5. The Vi-Go Automatic Cable Sleeve is now connected to the cable.
6. Check whether the cable sleeve can freely slide vertically on the cable.
7. Check the functioning of the locking and catch mechanism
by moving the latch.
To remove the Vi-Go Automatic Cable Sleeve from the cable:
1. While pushing upward on the shock absorber, press the lock knob.
2. With the lock knob pressed, push the slider into the casing.
3. Through the now-open cable channel gap, remove the cable sleeve.
4. Release the slider and the lock knob.
Us er Ins tru ct ion s - Engl is h
Integrated
Shock Absorber
Lock Knob
Latch
7
Max. Gap
when closed
1/4" (6.35mm)
Cable
Channel
Slider