Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. For long storage, it is recommended to store a fully charged battery
pack in a cool dry place out of the charger for optimal results.
note: Battery packs should not be stored completely depleted of
charge. The battery pack will need to be recharged before use.
SAve THeSe inSTrucTionS
components (fig. 2)
A. Variable speed trigger switch
B. Lock-off lever
C. Chain brake / front hand guard
D. Guide bar
E. Saw chain
F. Sprocket cover
G. Bar adjust locking knob
H. Chain tensioning knob
FIG. 2
N
O
L
B
M
A
K
H
F
G
J
All manuals and user guides at all-guides.com
I. Oil level indicator
J. Guide bar scabbard
K. Rear handle
L. Front handle
M. Battery housing
N. Battery Pack
O. Battery release button
P. Oil cap (not shown)
C
P
E
I
D
12
operation
installing and removing the Battery Pack
(fig. 3–4)
WARNING:
make certain the lock-off lever is engaged to prevent switch actuation.
To install battery pack: Insert battery pack (N) into battery housing
(Q) as shown in figure 3 until fully seated and an audible click is heard.
Make sure battery pack is fully seated and fully latched into position.
FIG. 3
N
Q
To remove battery pack: Depress the battery release button (O) in
the back of the battery housing and pull battery pack out of tool as
shown in figure 4.
FUeL GAUGe BATTeRY PACKS (FiG. 5)
Some D
WALT battery packs include a fuel gauge which consists of
e
three green LED lights that indicate the level of charge remaining in
the battery pack.
To actuate the fuel gauge, press and hold the fuel gauge button (5A).
A combination of the three green LED lights will illuminate designating
Before removing or installing battery,
FIG. 4
O
Publicité
Table des Matières
