Before Calling For Service - Panasonic PT-L735NTU Mode D'emploi

Before calling for service

Before calling for service, check the following points.
Problem
Power does not
turn on.
No picture
appears.
The picture is
fuzzy.
COLOR is too
light or TINT is
poor.
No sound can
be heard.
The remote
control unit
does not
operate.
The buttons on
the projector do
not function.
58-E
NGLISH
B The power cord may not be connected.
B The MAIN POWER switch is turned off.
B The main power supply is not being supplied to the
wall outlet.
B TEMP indicator is illuminated or flashing.
B LAMP indicator is illuminated or flashing.
B The lamp unit cover has not been securely installed.
B The video signal input source may not be
connected properly.
B The input selection setting may not be correct.
B The BRIGHT adjustment setting may be at the
minimum possible setting.
B The shutter function may be in use.
B The lens cover may still be attached to the lens.
B The lens focus may not have been set correctly.
B The projector may not be at the correct distance
from the screen.
B The lens may be dirty.
B The projector may be tilted too much.
B COLOR or TINT adjustment may be incorrect.
B The input source which is connected to the
projector may not be adjusted correctly.
B The audio signal source may not be connected properly.
B The volume adjustment may be at the lowest
possible setting.
B A cable may be connected to the AUDIO OUT jack.
B The MUTE function may be active.
B The battery may be weak.
B The battery may not be inserted correctly.
B The remote control signal receptor on the projector
may be obstructed.
B The remote control unit may be out of the
operation range.
B The CONTROL KEY may be set to "OFF".
In order to set the CONTROL KEY to "ON" without
using the remote control unit, keep holding down
the ENTER button on the projector and press the
MENU button for more than 2 seconds. It will then
be turned ON.
Possible cause Page
–
–
–
52
53
–
–
24
38
28
–
24
19
–
19
38
–
–
29,
44
20,
21
44
–
22
22
22
47