Store The Machine; Troubleshooting; Technical Data - GreenWorks MO13B00 Manuel D'opérateur

EN
5. Use a piece of wood to prevent the movement of the
blade.
6. Remove the mounting nut (18) and spacers (19) with a
wrench or socket.
7. Remove the blade (20).
8. Install the new blade. Make sure that the raised points
engage the holes in the blade.
9. Put in the mounting nut and spacers and tighten them.
Recommended tightening torque: 33-37 N.M.
9.3

STORE THE MACHINE

• Clean the machine before storage.
• Make sure the motor is not hot when you put the machine
into storage.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service center.
• Store the machine in a dry area.
• Make sure that children cannot come near the machine.
You may lower the handle(s) before you put the machine into
the storage.
1. Fully loosen the handle fasteners on the sides of the
handle(s).
2. Fold away the handle(s).
3. Do not pinch or trap the cables.
10

TROUBLESHOOTING

Problem
The handle is not
in position.
The machine does
not start.
Possible cause Solution
The bolts are not Adjust the height
engaged correctly. of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
The extension ca- Reconnect the ca-
ble is not connec- ble.
ted to the outlet.
The extension ca- Connect the exten-
ble is not connec- sion cable to a live
ted to the power 120V AC, 60 HZ
supply. AC receptacle.
The bail switch is Replace the bail
defective. switch.
English
Problem
The machine cuts
grass unevenly.
The machine does
not mulch correct-
ly.
The machine is
hard to push.
There is a high vi-
bration in the ma-
chine.
The machine stops
during mowing.
* If you cannot find the solution to these problems, go to the
service center.
11

TECHNICAL DATA

Motor
No load speed
Height adjustments
Functions
12
Possible cause Solution
The lawn is rough. Examine the mow-
ing area.
The blade height is Move the wheels
not set correctly. to a higher posi-
tion.
Wet grass clip- Wait until the
pings attach to the grass dries before
deck. mowing.
The mulch plug is Install the mulch
missing. plug.
The grass is too Increase the blade
tall, or the blade height.
height is too low.
The grass catcher Empty the grass
and the blade clippings from the
drags in thick grass catcher.
grass.
The blade is un- Replace the blade.
balanced and
worn.
The engine shaft is 1. Stop the en-
bent. gine.
2. Disconnect the
power supply.
3. Inspect for
damage.
4. Repair the ma-
chine before
you start it
again.
The blade height is Increase the blade
too low. height.
The grass clip- Disconnect the
pings attach to the power supply and
deck or the blade. check the deck.
Operation temper- Cool the machine.
ature of the ma-
chine is too high.
120 V AC, 60 Hz, 13 A
3600 RPM
1 3/8 - 3 3/4" (3.5 - 9.5 cm)
3-in-1 Mulch & rear bag &
side discharge