Assemble The Trimmer Head; Remove The Trimmer Head; Assemble The Brush Cutter; Remove The Brush Cutter - GreenWorks GD40BC Manuel Opérateur

EN
4. Put the lines in the guide slots.
5. Do not wind the lines beyond the edge of the spool.
5.5

ASSEMBLE THE TRIMMER HEAD

Figure 17.
1. Put the spacer correctly on the shaft.
2. Attach the inner ring-nut to inner cup in the indicated
direction.
3. Make sure that the grooves of the inner ring-nut
align perfectly with those of the angle transmission.
4. Put the wrench in the specified angle transmission
hole.
5. Turn the trimmer head and push the wrench until the
wrench engages the inner ring-nut hole, blocking
rotation.
6. Assemble the trimmer head.
7. Turn the trimmer head counterclockwise to tighten it.
8. Remove the wrench.
You must install the cut-off blade when you use the
trimmer head.
5.6

REMOVE THE TRIMMER HEAD

Figure 17.
1. Put the wrench in the specified angle transmission
hole.
2. Turn the trimmer head and push the wrench until the
wrench engages the inner ring-nut hole, blocking
rotation.
3. Turn the trimmer head clockwise to loosen it. Do not
remove the spacer from the shaft.
5.7

ASSEMBLE THE BRUSH CUTTER

Figure 18.
Wear gloves and be careful with sharp edges.
Apply the guard to the blade.
1. Put the spacer correctly on the shaft.
2. Attach the inner ring-nut to inner cup in the indicated
direction.
3. Make sure that the grooves of the inner ring-nut
align perfectly with those of the angle transmission.
4. Attach the blade and outer ring-nut with the flat part
facing the blade.
5. Attach the outer cup without tightening the nut.
IMPORTANT
WARNING
WARNING
English
6. Put the wrench in the specified angle transmission
hole.
7. Turn the blade and push the wrench until the blade
fits in the inner ring-nut hole, blocking rotation.
8. Tighten the nut counterclockwise with a 19 mm or
3/4 in. wrench (44/58 Nm).
5.8

REMOVE THE BRUSH CUTTER

Figure 18.
Apply the guard to the blade.
1. Put the wrench in the specified angle transmission
hole.
2. Trun the blade and push the wrench until the
wrench engages the inner ring-nut hole, blocking
rotation.
3. Loosen the nut clockwise and remove the outer cup.
4. Remove the outer ring-nut, blade, inner cup and
inner ring-nut. Do not remove the spacer from the
shaft.
6 TRANSPORTATION AND
STORAGE
6.1

MOVE THE MACHINE

When you move the machine, you must:
• Wear gloves.
• Stop the machine.
• Remove the battery pack and charge it.
• Assemble the blade guard.
6.2

STORE THE MACHINE

• Remove the battery pack from the machine.
• Make sure that children cannot come near the
machine.
• Keep the machine away from corrosive agents such
as garden chemicals and de-icing salts.
• Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine
for any damage.
8
WARNING