Description; Purpose; Overview; Packing List - GreenWorks GD60LM46SP Manuel Opérateur

EN
1

DESCRIPTION

1.1

PURPOSE

This machine is used for domestic lawn mowing. The cutting
blade must be approximately parallel to the ground. All four
wheels must touch the ground while mowing.
1.2

OVERVIEW

Figure 1~13
Start button
1
Start handle
2
Self-propel drive lever
3
Upper handle
4
Lower handle
5
Grass catcher
6
Rear discharge flap
7
Height adjustment lever
8
Battery compartment flap
9
Mulch plug
10
Side discharge chute
11
Handle hole
12
Handle bolt
13
Handle nut
14
Handle pin
15
Grass catcher handle
16
Grass catcher hook
17
Door rod
18
Side discharge flap
19
Pivot
20
Safety key
21
Battery pack
22
Battery capacity indicator
23
Self-propel speed control
24
Blade bolt
25
Spacer
26
Blade
27
Battery release button
28
Turbo button
29
Headlight
30
Rubber edge guard
31
1.3

PACKING LIST

1 Lawn mower
2 Grass catcher
English
3 Side discharge chute
4 Manual
2

SAFETY

WARNING
Make sure that you follow all safety instructions.
Refer to Safety Manual.
3

INSTALLATION

WARNING
Do not use accessories that are not recommended by the
manufacturer.
WARNING
Do not put in the safety key or the battery pack until you
finalised the assembly of all the parts.
3.1

UNPACK THE MACHINE

WARNING
Make sure that you correctly assemble the machine before
use.
WARNING
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
3.2 UNPACKING AND HANDLE
ASSEMBLY
Figure 2
1. Place the mower upright in vertical position.
2. Remove the packing material from the cable.
3. Remove the rubber edge guard from the upper handle.
4. Insert the upper handle into the lower handle.
5. Put the bolts through the holes and tighten with the nuts.
WARNING
Do not damage the cable while installing the upper handle.
4