Operation Tips; Maintenance; General Maintenance; Replace The Blade - GreenWorks MO09B01 Manuel D'opérateur

8.6

OPERATION TIPS

• Do not try to override the operation of the start button or
handle switch.
• Do not tilt the machine when you start it.
• Do not put hands or feet near or below the turning parts.
• Keep the discharge chute clean.
• Do not cut wet grass.
• Higher blade height is necessary for new or thick grass.
• Clean the bottom of the mower deck after each use.
Remove grass clippings, leaves, dirt, and other debris.
9

MAINTENANCE

WARNING
Disconnect the machine from power supply before
maintenance.
WARNING
Keep the engine free from grass, leaves or too much grease.
CAUTION
Use only approved replacement parts.
CAUTION
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
9.1

GENERAL MAINTENANCE

• Before each use, examine the machine for damaged,
missing, or loose parts such as screws, nuts, bolts and
caps.
• Tighten correctly all the fasteners and caps.
• Clean the machine with a dry cloth. Do not use water.
English
9.2

REPLACE THE BLADE

Use only approved replacement blades.
Wear heavy gloves or wind cloth around the blade when
you touch the blade.
1. Stop the machine.
2. Make sure that the blade fully stops.
3. Disconnect the machine from the power supply.
4. Turn the machine to its side.
5. Use a piece of wood to prevent the movement of the
blade.
6. Remove the blade nut (13), the washer (14) with a
wrench or socket.
7. Remove the blade (15).
8. Install the new blade. Make sure the raised points engage
the holes in the blade.
9. Put in the blade nut, the washer and tighten them.
Recommended tightening torque: 33-37 N.M.
9.3

STORE THE MACHINE

• Clean the machine before storage.
• Make sure the motor is not hot when you put the machine
into storage.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
11
15
14
13
WARNING
WARNING
EN