Led Headlights; Empty The Grass Catcher; Operation Tips; Maintenance - GreenWorks MO48L4423 Manuel D'utilisation

EN
8.4

LED HEADLIGHTS

1
9
1. When the mower is ready to start, you may grab the start
handle (2) or the self-propel lever (3) to turn on the LED
headlights (9).
2. Release the start handles and self-propel levers to turn off
the headlights.
8.5

EMPTY THE GRASS CATCHER

1. Stop the machine.
2. Remove the safety key.
3. Remove the battery pack.
4. Open the rear discharge door and hold it.
5. Hold the grass catcher by its handle and unhook it from
the door rod.
6. Close the rear discharge door.
7. Empty the grass catcher.
8.6

OPERATION TIPS

• Do not try to override the operation of the start button or
start handles.
• Do not tilt the machine when you start it.
• Do not put hands or feet near or below the turning parts.
• Keep the discharge chute clean.
• Do not cut wet grass.
• Higher blade height is necessary for new or thick grass.
• Clean the bottom of the mower deck after each use.
Remove grass clippings, leaves, dirt, and other debris.
9

MAINTENANCE

Remove the safety key and battery pack from the machine
before maintenance.
2
3
WARNING
English
Keep the motor and battery pack free from grass, leaves or
too much grease.
Use only approved replacement parts.
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Recommended tightening torque (blade): 33-37 Nm.
9.1

REPLACE THE BLADE

Use only approved replacement blades.
Wear heavy gloves or wind cloth around the blade when
you touch the blade.
1. Stop the machine.
2. Make sure that the blade (27) is fully stopped.
3. Remove the safety key and battery pack.
4. Turn the machine to its side.
12
WARNING
CAUTION
CAUTION
CAUTION
NOTE
27
26
25
WARNING
WARNING
NOTE