Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
White spot compensation
To compensate for the detected white spots, set the PIXEL COMP to ON.
(
page 57 PIXEL COMP.)
MEMO
• The camera's white spot compensation function cannot compensate completely for all white spots.
White spot detection and compensation by this camera must be performed under the following con-
ditions. White spot compensation is not possible under other con-
ditions. Even when these conditions are met, the properties of the
white spots may prevent compensation.
Detection and compensation area: Area of 1024X1024 pixels at
the center of the screen.
No. of detections and compensations: Within a total of 15 spots.
• The screen shown on the right may appear if light enters the CCD
while white spot detection is being performed, or due to the con-
ditions of the white spots. In this case, confirm that light is not
entering the CCD. If light is not entering the CCD but the screen
nevertheless remain displayed, accelerate the shutter one step
and perform the detection again.
• When white spot compensation is carried out, the compensation
of the pixel data is performed based on surrounding pixel data, which means that accurate data may
not be obtained in case of an image with fine details.
• The result of the white spot detection is retained until the next white spot detection is performed.
All manuals and user guides at all-guides.com
P I XE L CHECK
N G
E35
Publicité
Table des Matières
