Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. Settings and adjustments for recording
Setting the dip switches
The type of PC monitor to use and the ID during SCSI connection are set using the dip switches.
SCSI
SEND
MENU
UP
MONITOR
REMOTE
ON 1 2 3 4
Dip switches
SEE INSTRUCTION MANUAL
Monitor output settings
Dip switch no. 3 is set depending on whether using a system which uses a commercially avail-
able VGA monitor or a system which uses a capture board. < Default setting: OFF >
ON 1 2 3 4
Set to OFF
ON 1 2 3 4
Set to ON
SCSI ID settings
DiP switches 1 and 2 are set depending on the used system to set the SCSI ID. < Default ID: 7 >
ON 1 2 3 4
ID=7
ON 1 2 3 4
ID=6
ON 1 2 3 4
ID=5
ON 1 2 3 4
ID=4
E24
All manuals and user guides at all-guides.com
REC
AW/SEL
MODE
DOWN
SET
PLAY
FREEZE
Turn the power off before setting the dip switches. Setting
LENS
the switches with the power on will not change the set-
DC IN
tings.
POWER
VGA output setting
Set when directly connecting a VGA monitor to the MONITOR ter-
minal on the rear of the main unit.
SXGA output setting
Set for systems using a capture board.
The signal from the MONITOR terminal on the rear of the main unit
is inputted through the analog input compatible video capture board.
(
Page 68 Capturing images using the image capture board)
Set when connecting a printer or MO drive unit directly to the main
unit. When making this setting, the main unit will become the initia-
tor.
Set when exporting images to a PC.
Make sure that the ID numbers of the connecting devices are not
the same.
When making this setting, the PC will become the initiator and the
main unit will become the target.
(
Page 66 Connecting to a PC)
CAUTION
Publicité
Table des Matières
