Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Before recording (continued)
Connecting power
Between the 8 pin DC IN terminal on the rear of the main unit and the 8 pin TO CAMERA
terminal of the AC adapter (AA-P700) connect the power cable (2m) which is provided.
AC
White marking
Connect the end with the
white marking to the AC
adapter.
CAUTION
• Be sure to use the AA-P700 power supply.
• Before connecting power cable, make sure that the power switch on the AA-P700 is set to OFF.
Connecting with the power switch on may result in camera malfunction.
MEMO
• Wait at least 10 seconds before turning the power switch back on, when it has just been turned off.
• Turning the power switch on and off quickly may cause malfunctions, such as failure to boot, etc.
Figure 1
Ring
Plug
Figure 2
Figure 3
E18
All manuals and user guides at all-guides.com
AA-P700
DC 12V=OUTPUT
VIDEO OUTPUT
S(Y/C) OUTPUT
TO CAMERA
EITHER
SEE INST-
OUTPUT
RUCTION
MAX 1.25A
MANUAL
AC adapter
After inserting the plug completely, tighten the secur-
ing ring. (Figure 1)
Make sure white indication of power cable comes to
AA-P700 side.
To minimise emission of unwanted electrical waves,
mount certainly the provided clamp filter as shown in
Figure 2 and 3 on the left.
Wind the power cable once around the clamp filter.
Ensure that the clamp filter is mounted as close to
the camera as possible as shown in the diagram.
SCSI
MONITOR
REMOTE
ON 1 2 3 4
SEE INSTRUCTION MANUAL
Provided power cable
REC
SEND
AW/SEL
MODE
MENU
UP
DOWN
SET
PLAY
FREEZE
LENS
DC IN
POWER
Provided
Clamp filter
Publicité
Table des Matières
