Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Before recording (continued)
Connecting an MO/Zip
It is possible to output image data stored in the main unit memory to an MO drive or a Zip
(
Page 38 Saving images from the memory to an MO/Zip
CAUTION
Before connecting, make sure that the power of all sys-
tems are turned off. Connecting with the power turned on
may result in malfunction.
The MO/Zip
®
drive must be equipped with a terminator
power supply.
Recommended Zip
®
iomega Zip
250 (for SCSI
connection)
• Be sure to terminate the last device on the SCSI bus.
To directly connect the MO drive to the main unit, set the dip switches on the rear of the main unit
as shown below.
ON 1 2 3 4
MEMO
• Turn on the camera power after turning on the MO/Zip
era power when turning the MO/Zip
• Use a formatted DOS/V disk.
• Connecting two or more MO/Zip
Neither is it possible to connect an MO drive and a Zip
• The image data outputted to an MO/Zip
mode is VGA or SXGA, or whether the VGA mode is set to FINE or DRAFT.
• The maximum allowed length of the SCSI cable is 3m.
• It is not possible to simultaneously output the image data to a printer and MO/Zip
• The image data will be save as uncompressed TIF files (one file approx. 4 megabytes).
E20
All manuals and user guides at all-guides.com
®
drive
®
drive:
Set the ID of the MO drive side to other than 7.
(ID : 7)
®
drive power off.
®
drives at the same time is not possible.
drive unit will be 1360 × 1024 pixels, regardless whether the
®
®
disk)
Dip switches
SCSI
MONITOR
REMOTE
ON 1 2 3 4
SEE INSTRUCTION MANUAL
SCSI terminal
CAUTION
®
drive power. Furthermore, reinsert the cam-
®
drive at the same time.
REC
MODE
SEND
AW/SEL
MENU
UP
DOWN
SET
PLAY
FREEZE
LENS
DC IN
POWER
®
drive.
®
drive.
Publicité
Table des Matières
