Starting A Wash Cycle - Inglis 220 Serie Guide D'utilisation Et D'entretien

STARTING YOUR DISHWASHER

Starting a wash cycle

1. Load the dishwasher. See the "Loading
Your Dishwasher" section.
2. Spin the spray arm. It should turn freely.
3. Add detergent. See the "Using the
Dispensers" section.
4. Add rinse agent, if needed.
5. Close door firmly until it latches.
Stopping the dishwasher
You can stop your dishwasher anytime
during a cycle. All you have to do is:
• Open the door slightly. Wait for any filling
or spraying action to stop before opening
the door all the way. Close the door to
continue the cycle.
8
All manuals and user guides at all-guides.com
6. Run hot water at the sink nearest the
7. Press the desired Cycle and Option
8. Turn the Cycle Control knob clockwise to
• Turn the Cycle Control knob slowly clock-
dishwasher until water is hot.
Turn off water.
selections. (See the "Setting
the controls" section.)
NOTE: Select Air Dry for the
Rinse & Hold cycle.
the desired cycle. You will
feel a definite "stop" at each
cycle mark. The dishwasher
automatically starts the cycle
you select.
NOTE: If the door is latched, you will hear
the cycles start and stop as the control
knob passes each cycle mark. This is
normal and does not hurt the dishwasher.
If you prefer, you can set the Cycle
Control knob with the door unlatched.
OR
wise until you hear water draining.
Let the dishwasher drain completely. Then
open the door and turn the Cycle Control
knob to Off.