Inglis 220 Serie Guide D'utilisation Et D'entretien page 26

SOLVING COMMON DISHWASHING PROBLEMS
PROBLEM CAUSE
Spotting and Incorrect amount
filming of detergent
(continued)
Use of ineffective
detergents
Insufficient fill due to
low water pressure
Dishes do not drain
Dishes do not
properly
dry completely
Plastics
Silica film or Water chemical
etching reaction with certain
(silica film is a types of glassware –
white iridescent usually caused by
deposit; etching some combination of
is a cloudy film) soft or softened water,
alkaline washing
solutions, insufficient
rinsing, overloading the
dishwasher, and heat
of drying.
Black or gray Aluminum items
marks on dishes touching dishes
White spots on
Seasoning removed by
cookware with dishwasher detergents
non-stick finish
26
All manuals and user guides at all-guides.com
SOLUTION
Follow recommendations for amount. Heavy
soil and/or hard water generally require
extra detergent.
Use fresh detergent. Store detergent
tightly closed in a cool, dry place. Discard
lumpy detergent.
Home water pressure should be 20 to 120
psi (138 to 828 kPa) for proper dishwasher
fill. A booster pump on the water supply may
be necessary if pressure is too low.
Dishes must have proper water drainage.
Do not overload. See the "Loading Your
Dishwasher" section. Use a liquid rinse
agent to speed draining.
Some plastics, due to material, may need to
be towel dried.
It may not be possible to prevent problem,
except by hand washing. To slow this
process, use a minimum amount of deter-
gent but not less than 1 tablespoon per
load. Use a liquid rinse agent and underload
the dishwasher to allow thorough rinsing.
Silica film and etching are permanent and
cannot be removed. Use the Air Dry option.
Load aluminum items so that they will not
rub against dishes during washing. Do not
wash throwaway aluminum items in the
dishwasher because they may break down
and cause marking. Remove aluminum
markings by using a mild abrasive cleanser.
Reseason cookware after dishwasher
washing.