Using Delay Wash; Changing A Cycle Setting; Adding An Item During A Cycle - Inglis 220 Serie Guide D'utilisation Et D'entretien

SETTING THE CONTROLS

Using delay wash

(on some models)
You can set the dishwasher to start a cycle
3 hours later.
1. Press the desired Cycle button.
2. Press the desired Option button.
3. Turn the Cycle Control knob clockwise to
the number 3 if you want the dishwasher
to delay before the selected cycle starts.
4. Close and latch the door.
NOTES:
• You can add items while time is counting
down. Close and latch the door. The
Cycle Control knob will not advance if the
door is unlatched.
• The Light Wash and Rinse & Hold cycles
cannot be delayed.

Changing a cycle setting

You can change a cycle setting anytime
during any cycle.
1. Lift up the door latch to stop the cycle.
2. Turn the Cycle Control knob clockwise to
the desired cycle.
3. Check the detergent dispensers. They
must be filled properly for the new cycle.

Adding an item during a cycle

You can add an item to the dishwasher
anytime before the main wash portion of a
cycle. See the "Selecting a wash cycle"
chart. Items added after the Cycle Control
knob reaches Light Wash will only be
rinsed.
1. Lift up the door latch to stop the cycle.
Wait for spraying action to stop before
opening the door.
2. Open the door and add the item.
16
All manuals and user guides at all-guides.com
4. Close the door firmly until it latches. The
3. Close the door, but do not latch it. Wait
4. Close the door firmly until it latches. The
Punched Hole
LIGHT WASH 52.50/52.0 Dia.
DU850
NORMAL WASH
3
DELAY HOURS
NOTE: Turning the Cycle Control knob
can cause the covered section of the
detergent dispenser to open and release
the detergent. Check the covered section
if setting Normal Wash or Pots -N- Pans
cycle.
dishwasher starts the new cycle.
30 seconds for the air in the dishwasher
to warm up. Doing so reduces the amount
of moisture in the vent when restarting
a cycle.
dishwasher resumes the cycle.
RINSE ONLY
USE AIR DRY
RINSE
DRY