Adding An Item During A Cycle; Using Delay Wash - Inglis 355 Série Guide D'utilisation Et D'entretien

SETTING THE CONTROLS

Adding an item during a cycle

You can add an additional item to the
dishwasher anytime before the Cycle Control
knob reaches Light wash. Items added after
the Cycle Control knob reaches Light wash
may only be rinsed.
1. Lift up the door latch to stop the cycle.
Wait for spraying action to stop before
opening the door.
2. Open the door and add the item.

Using delay wash

You can set the dishwasher to start a cycle
from 2 to 4 hours later.
1. Press the desired Cycle pad.
2. Press one or more option pads.
3. Turn the Cycle Control knob clockwise to
the number of hours (from 2 to 4 hours)
you want the dishwasher to delay before
the selected cycle starts.
4. Close and latch the door.
NOTES:
• You can add items while time is counting
down. Close and latch the door. The Cycle
Control knob will not advance if the door is
unlatched.
• Rinse - Wash Later and Light wash cycles
cannot be delayed.
16
3. Close the door, but do not latch it. Wait
30 seconds for the air in the dishwasher
to warm up. Doing so reduces the
amount of moisture in the vent when
restarting a cycle.
4. Close the door firmly until it latches. The
dishwasher resumes the cycle.
Punched Hole
52.50/52.0 Dia.
2
DELAY HOURS
4
DU400