Starting A Wash Cycle - Inglis 355 Série Guide D'utilisation Et D'entretien

Starting a wash cycle

1. Load the dishwasher. See the "Loading
Your Dishwasher" section.
2. Spin the spray arms. They should turn
freely.
3. Add detergent. See the "Using the
Dispensers" section.
4. Add rinse agent, if needed.
5. Close door firmly until it latches.
Stopping the dishwasher
You can stop your dishwasher anytime
during a cycle. All you have to do is:
• Open the door slightly. Wait for any filling
or spraying action to stop before opening
the door all the way. Close the door to
continue the cycle.
STARTING YOUR DISHWASHER
6. Run hot water at the sink nearest the
dishwasher until water is hot.
Turn off water.
7. Press a Cycle pad. If desired, press one
or more Option pads. See
the "Setting the Controls"
section.
NOTE: Normal wash, Light
wash and Rinse - Wash Later
share the same pad. The Cycle Control
knob determines which cycle operates.
8. Turn the Cycle Control knob clockwise to
the desired cycle. You will
feel a definite "stop" at each
cycle mark. The dishwasher
automatically starts the cycle
you select.
NOTE: If the door is latched, you will
hear the cycles start and stop as the
Cycle Control knob passes each cycle
mark. This is normal and does not hurt
the dishwasher. If you prefer, you can set
the Cycle Control knob with the door
unlatched.
OR
• Turn the Cycle Control knob slowly
clockwise until you hear water draining.
Let the dishwasher drain completely. Then
open the door and turn the Cycle Control
knob to Off.
7