Inglis 220 Serie Guide D'utilisation Et D'entretien page 23

All manuals and user guides at all-guides.com
4. Place a shallow pan under the water
supply valve. Then, use a wrench to
disconnect the water inlet from the water
supply valve. Separate the water inlet
from the water supply valve and drain
water into the pan.
5. Remove the spring clamp from the water
outlet and separate from the water
supply valve; drain water into pan.
6. Reconnect both water inlet and water
outlet to the water supply valve.
7. Empty the pan and reposition it under
the water pump.
8. Remove the clamp and disconnect the
drain hose from the water pump; drain
water into pan.
9. Reconnect drain hose to the water
pump, being sure to position the clamp
over the connection.
10. Replace the lower access panel.
NOTE: If your dishwasher is connected to
a garbage disposal, do not run water into
the sink after winterizing. This could cause
water to refill the drain hose on your
dishwasher.
Reconnecting your dishwasher
1. Remove the 4 screws on the lower
access panel and remove lower
access panel.
2. Turn on the water supply to dishwasher.
3. Reconnect power or plug in dishwasher.
4. Run dishwasher through a complete
cycle and check for leaks.
5. Replace lower access panel.
Storing for the summer
Protect your dishwasher during the summer
months by turning off the water supply and
power supply to the dishwasher.
CARING FOR YOUR DISHWASHER
Built-in models
Spring
Water outlet clamp
Water supply
valve
Portable models
Spring
Water outlet
clamp
Water supply Water
valve inlet
Water pump
and motor
Water Drain
hose
inlet
Screw
Water pump
clamp
and motor
Drain hose
23