Installation; Mounting In The Rack - Panasonic WV-CU161 Mode D'emploi

INSTALLATION

The installation should be made by qualified service personnel or system installers according to the following instruc-
tions.

Mounting in the Rack

Note: Keep the Power On/Off Switch turned off while mak-
ing the following installations.
1. Remove the Connector Panel and Bottom Cover from
the controller by removing the four screws.
2. Mount the Connector Panel onto the bottom by using
the two screws removed above.
3. Mount the Bottom Cover onto the rear by using the two
screws removed above.
4. Remove the side panels by removing the four screws.
5. Remove the Palm Rest Panel by removing the two
screws.
6. Mount the Rack Mounting Angles onto both sides by
using the four screws.
7. Mount the controller in the EIA standard 19-inch rack.
Caution: Always keep the temperature in the rack within
45°C (122°F).
32
All manuals and user guides at all-guides.com
Connector Panel
Bottom Cover
Bottom Cover
Connector Panel
2
Side Panel
(Left)
3
5
(Procured locally)
4
(Supplied:
WV-Q62)
Rack Mounting Angle
(Optional Accessory: WV-Q62)
Remove
Side Panel
(Right)
Palm Rest Panel
5
(Procured locally)
4
(Supplied:
WV-Q62)
2