System Setup - Panasonic WV-CU161 Mode D'emploi

• For using alarm input terminals 1-4
ALARM DISPLAY ON
SITE ALARM
TERM.ALARM
ALARM OUTPUT
ALARM BUZZER
ALARM TERMINAL
1. Display the ALARM SETUP menu.
2. Select ALARM TERMINAL by moving the joystick up
or down.
3. Press the PRESET/SET/PROGRAM PRESET button.
The ALARM TERMINAL screen appears as shown
below.
ALARM
4. Select the alarm terminal number by moving the joy-
stick up or down.
5. Move the joystick to the right or left to select the
desired preset numbers of the picture on the moni-
tor in the range of 1-64, or [–] if no preset numbers
are assigned.
The initial factory setting is – (No assignment).
1-64: Preset numbers
–: No assignment
6. To return to the previous menu, press the
HOME/ESC button.
Notes:
• ALARM TERMINAL is available only when a combi-
nation camera is connected.
• If the camera has the Preset Alarm ON/OFF mode,
set it to OFF.
19
All manuals and user guides at all-guides.com
ALARM SETUP
ON
ON
10S
ON
ALARM TERMINAL
PRESET
1 -
2 -
3 -
4 -

System Setup

1. Display the Setup menu.
2. Select SYSTEM SETUP by moving the joystick up or
down.
3. Press the PRESET/SET/PROGRAM PRESET button.
The SYSTEM SETUP menu appears on the monitor as
shown below.
SYSTEM SETUP
CABLE COMP
SWITCH BUZZER ON
(1) Cable Compensation Setting
This item lets you select the cable length to compensate for
transmission loss.
1. Display the SYSTEM SETUP menu.
2. Select CABLE COMP by moving the joystick up or
down.
3. Select the most suitable cable length by moving the joy-
stick to the right or left.
The initial factory setting is S.
S: Less than 400 m (1 300 ft)
M: 400 m (1 300 ft) to 700 m (2 300 ft)
L: 700 m (2 300 ft) to 900 m (3 000 ft)
(When using RG-59U, BELDEN 9259 or equivalent
cable)
(2) Switch Buzzer Setting
This item lets you select whether or not the switch buzzer
sounds when a button is pressed.
1. Display the SYSTEM SETUP menu.
2. Select SWITCH BUZZER by moving the joystick up or
down.
3. Select ON or OFF mode by moving the joystick to the
right or left.
The initial factory setting is ON.
S