Table Des Matières; Introduction - Thermador Professional P24WK Manuel D'entretien Et D'utilisation

Masquer les pouces Voir aussi pour Professional P24WK:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INTRODUCTION

The Thermador Professional
units available in a number of configurations. Models
PC486GE, PC486GL, PC484GGE and PC484WK
feature a gas cooking surface with six sealed burn-
ers and an electric griddle, six sealed burners and a
gas grill, four sealed burners with an electric griddle
and a gas grill, or four sealed burners with a wok,
respectively. Models PC364GE, PC364GL, and
PC366 feature a gas cooking surface with four sealed
burners and an electric griddle, four sealed burners
and a gas grill, or six sealed burners. Models P24WK
and PC484WK have a high output WOK burner rated
at 30,000 BTU/HR.
IMPORTANT
All Cooktops having less than 12" (305 mm)
horizontal clearance between combustible ma-
terials and the back edge of the Cooktop must
be installed with a Thermador Low Back Back-
guard. If more than 12" (305 mm) horizontal
clearance exists, a Thermador Island Trim may
be used instead of the backguard. Before using
the Cooktop, insure that it is equipped with the
appropriate Low Back Backguard or Island Trim.
Refer to the Installation Instructions accompa-
nying this appliance for more information.
Cooktops are shipped by the factory to operate on
natural gas. Verify the type of gas being used at the
installation site matches the type of gas used by the
appliance.
If the location/job site requires a conversion from
one type of gas to another, contact the dealer where
the unit was purchased or contact Thermador (800/
735-4328). The field conversion kit for all
Professional cooktops (PC series) is Thermador
Model PLPKIT. Field conversion must be done by
qualified service personnel only.
CAUTION
When connecting the unit to propane gas, make
certain the propane gas tank is equipped with
its own high-pressure regulator in addition to
the pressure regulator supplied with the range.
The pressure of the gas supplied to the appli-
ance regulator must not exceed 14" (34.9 milli-
bars) water column.
All manuals and user guides at all-guides.com
®
Cooktops are built-in
Contents
Introduction .................................................................... 1
Gas Type Verification ..................................................... 1
Safety Precautions ................................................... 3 - 4
Model & Parts Identification - PC48 .............................. 6
Model & Parts Identification - PC36 .............................. 7
Model & Parts Identification - P24WK ........................... 8
Sealed Burners .............................................................. 9
®
Burners ....................................................... 10
Electronic Igniter .......................................................... 10
Flame Setting Guidelines ............................................. 11
Cookware Recommendations ..................................... 12
Specialty Cookware ..................................................... 13
Using the Grill .................................................... 16 - 18
Grill Cooking Recommendations .................... 19 - 20
Using the Griddle ...................................................... 21
Griddle Cooking Recommendations ....................... 21
Before Using Prepare Wok ............................................ 5
Using the Wok .............................................................. 22
Wok Operation ............................................................. 23
Cooktop and Wok Cleaning Recommendations ... 24 - 28
Do-It-Yourself Maintenance ......................................... 29
Before Calling For Service ........................................... 30
Data Rating Plate ......................................................... 30
Warranty ....................................................................... 33
TESTED IN ACCORDANCE WITH ANSI
Z21.1, The STANDARD FOR HOUSEHOLD
COOKING GAS APPLIANCES. IN CANADA
TESTED IN ACCORDANCE WITH CAN/
CGA 1.1 - M81, STANDARD for DOMESTIC
GAS RANGES.
Check your local building codes for the proper
method of installation. In the absence of local
codes, this unit should be installed in accordance
with the National Fuel Gas Code No. Z223.1
current issue and the National Electrical Code
ANSI/NFPA No. 70 current issue or the Can - B149
Installation Codes for Gas Burning Appliances and
C22.1 Canadian Electrical Code Part 1.
1

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Professional pc36Professional pc48

Table des Matières