Panasonic WV-CW864A Mode D'emploi page 38

8. Match the vertical phase for both video output sig-
nals as closely as possible with the joystick.
** SYNC **
V PHASE
COARSE
FINE
RET
** SYNC **
V PHASE
COARSE
FINE
RET
Notes:
• When the "|" cursor reaches the "+" end, it jumps
back to "–". At the same time, COARSE is incre-
mented by one step to enable a continuous
adjustment. The reverse takes place when the "|"
cursor reaches the "–" end.
• When the joystick is kept at the right or left for
one second or more, the "|" cursor moves quick-
ly.
• To reset COARSE and FINE to the preset values,
press the F2 button of WV-CU550C. For WV-
RM70, press the right and left switches simulta-
neously. COARSE is preset to zero-crossing of
the AC line phase.
• If the AC line phase contains spike noise, etc.,
the vertical phase of the video output signal may
be disturbed.
● White Balance (WHITE BAL)
(1) Auto-Tracing White Balance Mode (ATW1/ ATW2)
1. Move the cursor to WHITE BAL and select ATW1
with the joystick. The white balance of the camera is
automatically adjusted.
** SET UP **
CAMERA ID
ALC/MANUAL
SHUTTER
AGC
SENS UP
SYNC
WHITE BAL
MOTION DET
AF MODE
RET
4(1--16)
••••••|••
- +
1(1--16)
•|•••••••
- +
OFF
ALC
AUTO
ON(MID)
OFF
INT
ATW1
OFF
AUTO L
SPECIAL2
2. For fine adjustment of ATW1/ATW2, press the CAM
(SET) key. The ATW1/ATW2 fine adjustment menu
appears on the monitor screen.
R
B
RET
3. Move the cursor to RET with the joystick and press
the CAM (SET) key to return to the SET UP menu.
(2) Automatic White Balance Control Mode (AWC)
1. Move the cursor to WHITE BAL and select AWC →
PUSH SW with the joystick.
CAMERA ID
ALC/MANUAL
SHUTTER
AGC
SENS UP
SYNC
WHITE BAL
MOTION DET
AF MODE
RET
2. Press the CAM (SET) key to start the white balance
setup. PUSH SW is highlighted to indicate that white
balance is being set.
3. PUSH SW returns to normal when balance setting is
completed.
4. For fine adjustment of the AWC, move the cursor to
AWC and press the CAM (SET) key. The AWC fine
adjustment menu appears on the monitor screen.
R
B
RET
5. Move the cursor to RET with the joystick and press
the CAM (SET) key to return to the SET UP menu.
-38-
** ATW1 **
••••|••••
- +
••••|••••
- +
** SET UP **
OFF
ALC
AUTO
ON(MID)
OFF
INT
AWC →PUSH SW
OFF
AUTO L
SPECIAL2
** AWC **
••••|••••
- +
••••|••••
- +