Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. Pan Offset
If the camera is replaced with a new one, the pan
offset function is used to adjust its positions to be
the same as before except patrol setting.
The system controller can download or upload the
preset position data.
Caution: The preset data for other cameras (WV-
CW654 for example) is incompatible with WV-
CW864A's. WV-CW864A's preset data will be
destroyed if you upload the conventional data. If
this happened, reset the WV-CW864A to the
default settings. Download the factory settings
into the controller and upload the correct preset
data newly to the initialized WV-CW864A.
(1) Display the PRESET NUMBER SET menu.
** PRESET NUMBER SET **
1*
5
9
13
17
21
25
29
ID:
33-64
(2) Select a position number for the picture to be most
enlarged among the numbers with the joystick. Then
press the CAM (SET) key. The position setting menu
appears.
(3) Move the cursor to PAN OFFSET SET and select the
right or left arrow with the joystick.
** POSITION 1***
PAN/TILT
ZOOM/FOCUS
PAN OFFSET SET ←
RET
(4) Press the CAM (SET) key until the desired offset
value appears.
(5) Move the cursor to an item other than PAN OFFSET
SET, and press the MON (ESC) key.
Notes:
• Further adjustment of the other positions is
unnecessary. This adjustment applies to all other
positions.
• Make sure to move the cursor before pressing
the key in step 5. Otherwise the settings will be
ignored.
• Retry the loading when the camera fails to
upload or download the data.
2
3
4
6
7
8
10
11
12
14
15
16
18
19
20
22
23
24
26
27
28
30
31
32
RET
→PUSH SET
→PUSH SET
0 →
4. To Set the Lens Zoom and Focus Positions
(1) Move the cursor to PUSH SET for ZOOM/FOCUS
and press the CAM (SET) key. The ZOOM/FOCUS
setting menu appears.
PAN/TILT
ZOOM/FOCUS
PAN OFFSET SET ←
RET
(2) Select a zoom position by moving the zoom control
up and down and a focus position by moving the
focus control up and down, and then press the CAM
(SET) key.
PAN/TILT
ZOOM/FOCUS
PAN OFFSET SET ←
RET
The positions are set and the screen returns to the
position setting menu.
Notes:
• When the camera is used at a nearly horizontal
angle, the focus may not be adjustable to a high
level of accuracy.
• If you move the cursor to the position number
and move the joystick right or left, the position
number can be selected.
The selected preset position number can also be
set after pressing the CAM (SET) key.
• The preset and camera IDs appear in the lower-
left corner of the position setting menu after set-
ting them.
5. Move the cursor to RET and press the CAM (SET)
key to return to the preset setting menu.
PAN/TILT
ZOOM/FOCUS
PAN OFFSET SET ←
RET
-19-
** POSITION 1***
→PUSH SET
→PUSH SET
0 →
** POSITION 1***
→PUSH SET
→PUSH SET
U ZOOM D/L FOCUS R
0 →
** POSITION 1***
→PUSH SET
→PUSH SET
0 →
Publicité
Table des Matières
