Bosch JSH180 Consignes De Fonctionnement/Sécurité page 9

Slide charged battery pack into the housing
until the battery pack locks into position.
Your tool is equipped with a secondary locking
latch to prevent the battery pack from
completely falling out of the handle, should it
become loose due to vibration.
SWITCH LOCK
The switch lock is designed to prevent
accidental starts. To operate switch, press the
switch lock button with your thumb to the
unlock symbol. To lock the switch, press
the switch lock button to the lock
(Fig. 1).
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed trigger
switch. The tool can be turned "ON" or "OFF" by
squeezing or releasing the trigger. The speed
can be adjusted from the minimum to maximum
nameplate SPM by the pressure you apply to the
trigger. Apply more pressure to increase the
speed and release pressure to decrease speed
(Fig. 1).
When the trigger is released it activates the
electrical brake to stop the blade quickly. This
feature is especially useful when making
repetitive cuts.
BLADE ORBIT SELECTOR LEVER
Maximum cutting efficiency can be obtained
by adjusting the blade orbit selector lever to
suit the material being cut.
Operating Instructions
INSERTING AND RELEASING BATTERy PACK
BRAKE
To remove the battery pack, press the battery
pack release button and slide the battery pack
forward (Fig. 1).
Press the battery pack release button again
and slide the battery pack completely out of
tool housing.
The following chart will help you determine
which setting to use for your application. This
chart is intended as a guideline only, and test
cuts in scrap material should be performed
first to determine the best setting.
symbol
-9-
Setting O
Hard materials such as
metals or thin sheet metals.
This setting can be used with
knife blades, grit edge
blades, rasp work. and down
cutting blades.
Setting 1
Soft materials where cleaner
cutting or delicate scrolling
work is performed.
Setting 2
Medium density materials
such as harder woods or
particle board.
Setting 3
Soft materials such as wood,
plastics, etc. and when fast
cutting is more important
than a clean cut.