Refreshment Center Care; General Cleaning - KitchenAid KFFU271 Guide D'utilisation

5. Install water inlet connector through hole provided in cabinet
rear panel.
A
A. Plastic tubing from water filter
(inlet)
B. Hose connector
C. Hose connector nut
IMPORTANT: Always follow label instructions on cleaning
products.
Soap, water and a soft cloth or sponge are suggested first unless
otherwise noted.
To avoid weather damage use the accessory cover designed for
the Outdoor Refreshment Center.
STAINLESS STEEL
Cleaning Method:
Rub in direction of grain to avoid damaging stainless steel
surface.
Food spills should be cleaned as soon as possible. Spills may
cause permanent discoloration. Use stainless steel cleaner
and polish to clean spills.
KitchenAid ® Stainless Steel Cleaner and Polish Part Number
4396920 (not included) or KitchenAid
Part Number 8212510 (not included):
See "Assistance or Service" section to order.
Liquid detergent or all-purpose cleaner:
Rinse with clean water and dry with soft, lint-free cloth.
Vinegar for hard water spots
Use a glass cleaner to remove fingerprints.
To avoid damage to stainless steel surfaces, do not use soap-
filled scouring pads, abrasive cleaners, cleaners containing
chlorine, Cooktop Polishing Creme, steel-wool pads, gritty
washcloths or some paper towels.
8
C
B
D
E
F
D. Brass locking nut
E. Inlet connector (¾" MHT x ½"
MIP hose adapter)
F. Exterior side of mounting panel

REFRESHMENT CENTER CARE

General Cleaning

® Stainless Steel Wipes
6. Attach the plastic tubing from the water inlet connection to
the inlet side of the filter. Use NSF or UPC listed water
connection line for water supply to inlet connector. Potable
water supply system must be connected to inlet connector
according to local code requirements.
C
A. Plastic tubing
B. Inlet connector
C. Filter
D. NSF or UPC listed water supply line or hose
7. Unwrap the sliding cover and place into frame on top of the
ice bin.
8. Rotate the side shelves up into their locked position or leave
down as needed.
9. Lock the front locking caster wheels to keep refreshment
center from moving.
REFRESHMENT CENTER WATER FILTER
Filter should be replaced every 6 to 12 months.
To remove filter, turn filter counterclockwise ¹⁄₄ turn and
remove.
To install filter, push in new cartridge and turn clockwise.
REFRESHMENT CENTER EXTERIOR
The quality of this material resists most stains and pitting,
providing that the surface is kept clean and covered.
Cleaning Method:
Apply stainless steel polish to all areas before first use.
Apply after each cleaning to avoid damage refreshment
center exterior surface.
Cleaning should always be followed by rinsing with clean,
warm water.
Use a metal polish or stainless steel brightener to remove
fingerprints, water spots, oxidation, and food stains. Always
follow the manufacturer's directions.
Wipe the surface completely dry with a soft cloth.
Winterization of faucet and drain system
When temperatures are below 35°F (1.7°C) for an extended
period of time:
1. Turn off water source to sink.
2. Remove potable water supply system from inlet connection
and store it appropriately.
A
B
D