Replacing The Igniter Battery; Outdoor Grill Care; Changing The Light Bulb - KitchenAid 720-0745 Instructions D'installation Et Guide D'utilisation Et D'entretien

Replacing the Igniter Battery

If igniters stop sparking, the battery should be replaced.
1. The igniter button cap is located on the outside of the grill's
right side panel.
2. Unscrew igniter button cap counterclockwise to remove.
A. "AA" size battery
B. Igniter cap
3. Remove battery from the battery compartment.
4. Replace with a new alkaline "AA" size battery. Install battery
with negative end in first.
5. Screw igniter button cap clockwise into place.

Changing the Light Bulb

1. Unplug grill or disconnect power.
2. Make sure the light power switch on the control panel is in the
OFF position.
3. Use a Phillips screwdriver to remove the four screws securing
the light cover to the grill hood.
B
A
A. Remove these screws.
B. Grill hood
NOTE: When removing final screw from the light cover, make
sure to hold the cover in place, ensuring it doesn't fall and
shatter.
26

OUTDOOR GRILL CARE

A
B
A
4. Loosen the screw securing the light assembly to the grill
hood and pull out the light with glass light cover.
A
B
A. Screw
B. Light assembly
5. To remove glass light cover, remove screw and gently pry
downward with a small flat-blade screwdriver at the left edge
of the cover near the screw and pull away from the retainer.
Pull out the clamp from the end of the light assembly.
A
6. Use a flat-blade screwdriver to remove the screw locking the
bulb into place.
A
7. Remove bulb from socket.
A. Clamp
A. Screw