Drive Harmony 14200 Guide D'utilisation page 13

ON
Grounding:
See Grounding Instructions on Page 2.
4. Plug the power cord into electrical outlet.
NOTE:
Make sure the Control Unit is suitable for
the local power voltage.
The plug is also served to disconnect the
device. Do not position the equipment so
that it is diffi cult to disconnect the device.
CAUTION: The Control Unit can only
be applied to the matt ress recommended
by the manufacturer. Do not use it for any
other purpose.
5. Then turn the main power switch to ON
position.
6. Aft er installation, the extra length of
the power cord, if any, should be neatly
arranged through the cable management
loops on the left side of the matt ress to
avoid a tripping hazard.
NOTE: Do not connect any cable to the
reserved signal port next to the quick
connector. The cap should always
remain on.
11