Basic Set-Up And Connections; Initial Setup; Positioning The Tv - Sanyo DS25520 Manuel D'instructions

BASIC SET-UP & CONNECTIONS
QuickTips
The TV will automati-
I
cally select the correct
Antenna mode for the
type of signal you
connect.
TV will switch off
I
automatically after 15
minutes if there is no
signal reception (cable
out or station not
broadcasting).
Exception—When the
Video mode is selected,
the TV will not automati-
cally switch off when
signal reception has
stopped for 15 minutes.
If you move the TV to
I
a new location, press
the RESET key twice
after connecting the
signal and turning on
the TV.
Need help?
Visit our Web site at
www.sanyoctv.com
or Call 1-800-877-5032
CATV FRANCHISE NOTE:
Cable companies, like public
utilities, are franchised by
local government authorities.
To receive cable programs,
even with equipment which
is capable of receiving cable
channels, the consumer
must subscribe to the cable
company's service.
4 4
INITIAL SET-UP
1. Install batteries in remote control, see page 7.
2. Connect signal, see below.
3. Plug in AC power cord.
4. Press POWER key to turn on TV.
5. Follow on-screen instructions.
CONNECTING CABLE SERVICE, RF ANTENNA, OR SATELLITE DISH
RECEIVER TO TV
‚
Cable Service
NOTE: If you do not have a VCR
connect signal directly to TV 75
ohm jack.
Audio Output Jacks
Connect external audio equipment here.
Audio/Video Input Jacks (Video2)
Connect external video equipment here
(see page 6).
Note: For your convenience this TV is
designed with front A/ V Jacks (Video1)
to connect your video game, camcorder,
and other external video equipment as
shown on page 5.

POSITIONING THE TV

Do not position the TV in a confined
area. Allow space for normal air
circulation around electronic parts.
‚
Satellite Receiver
S-Video Input Terminal
To enhance video detail use the S-Video jack
instead of the Video jack, if available on your
external equipment. (S-Video connection will
override a connection to the rear Video jack.)
See page 6.
‚
RF Antenna
VCR Back
TV Back