Basic Set-Up And Connections - Sanyo DS31820 Manuel D'instructions

BASIC SET-UP AND CONNECTIONS

QuickTips
The TV will automati-
■
cally select the correct
Antenna mode for the
type of RF signal you
connect.
TV will switch off
■
automatically after 15
minutes if there is no
signal reception (cable
out or station not
broadcasting).
Exception—When the
Video mode is selected,
the TV will not automati-
cally switch off when
signal reception has
stopped for 15 minutes.
If you move the TV to a
■
new location, press the
RESET key twice after
connecting the signal
and turning on the TV.
Need help?
Visit our Web site at
www.sanyoctv.com
or Call 1-800-877-5032
CATV FRANCHISE NOTE:
Cable companies, like public
utilities, are franchised by
local government authorities.
To receive cable programs,
even with equipment which
is capable of receiving cable
channels, the consumer
must subscribe to the cable
company's service.
4
INITIAL SET-UP
1. Install batteries in remote control, see page 7.
2. Connect signal, see below.
3. Plug in AC power cord.
4. Press POWER key to turn on TV.
5. Follow on-screen instructions.
CONNECTING CABLE SERVICE, RF ANTENNA, OR SATELLITE DISH
RECEIVER TO TV
❶
Cable Service
Note: If you do not have a VCR
connect signal directly to TV 75
ohm jack.
S-Video Input Terminal
To enhance video detail use the AV1
S-Video jack instead of the AV1 Video jack,
if available on your external equipment. (An
S-Video connection will override connection
to the AV1 video input jack. See page 5.)
Audio Output Jacks
Connect external audio equipment here
(see page 6).
480i Component Video In Jacks
(Component 2, Y, Pb, Pr)
Connect digital video equipment here
(see page 6).
POSITIONING THE TV
Do not position the TV in a confined
area. Allow space for normal air
circulation around electronic parts.
❶
Satellite Receiver
CATV IN
CH3
CH4
VIDEO L- AUDIO -R IN FROM
OUT TO TV S-VIDEO SAT.
VIDEO L- AUDIO -R
IN
FROM ANT.
OUT
OUT TO TV
VIDEO AUDIO INPUT
COMPONENT AV2
S-VIDEO
Y
AUDIO
OUTPUT
P
b
L
P R
r
R
Audio/Video Input Jacks (AV1 / AV2)
Connect video equipment here (see
pages 5 ~ 6).
Note: S-Video connection will override
an AV1 video connection.
❶
RF Antenna
VCR Back
TV Back
AV1
UHF/VHF/CATV
VIDEO
75Ω
(MONO)
L L
R
AUDIO