Electrical Warnings - Oceanic OCEACLIM700W1 Guide D'utilisation

SAFETY INSTRUCTIONS
INSTALLATION
The appliance must be handled and installed by two or more persons - risk of
injury. Use protective gloves to unpack and install - risk of cuts.
Installation, including electrical connections, and repairs must be carried out by a
qualified technician according to national wiring rules.
Do not repair or replace any part of the appliance unless specifically stated in the
user manual.
Keep children away from the installation site. After unpacking the appliance, make
sure that it has not been damaged during transport.
In the event of problems, contact the dealer or your nearest After-sales Service.
Once installed, packaging waste (plastic, styrofoam parts etc.) must be stored out
of reach of children - risk of suffocation.
The appliance must be disconnected from all remote power supply before any
installation operation - risk of electric shock.
During installation, make sure the appliance does not damage the power cable -
risk of fire or electric shock. Only activate the appliance when the installation has
been completed.
Always leave a 20 cm gap around the appliance and a 50 cm gap above it.
Insufficient ventilation may cause overheating or fire.
To avoid potential fire hazards, ensure that the filter is installed before operating
the appliance.
Do not place the appliance near a heat source (risk of fire).
Avoid keeping flammable materials, such as alcohol, petrol or aerosols, near the
appliance (risk of explosion or fire).
Operate the appliance only on a level and stable surf ace. Disconnect power cord
before moving the appliance.

ELECTRICAL WARNINGS

The power supply must be of rated voltage with special circuitry for the appliance.
The diameter of the power cord must comply with requirements.
It must be possible to disconnect the appliance from the power supply by
unplugging. The appliance must be earthed in conformity with national electrical
safety standards.
The use of a time-delay fuse or time-delay circuit breaker is recommended. All
wiring must comply with local and national electrical regulations and be installed
by a qualified electrician.
Do not use extension leads, multiple sockets or adapters. The electrical
components must not be accessible to the user after installation. Do not use the
appliance when you are wet or barefoot. Do not operate this appliance if it has a
damaged power cable or plug, if it is not working properly, or if it has been
damaged or dropped.
If the supply cord is damaged, it must be replaced with an identical one by the
EN-2