Wall Mounting; Cleaning - SilverCrest EDS-SSM 600 B2 Mode D'emploi

Wall mounting

GB

Cleaning

50
2 plugs and 2 screws are supplied to enable the wall bracket 6 to be mounted.
WARNING RISK OF ELECTRIC SHOCK!
Before mounting the wall bracket 6, check whether there are any power
►
cables or pipes in the wall!
1) Mark the positions for the drill holes using the wall bracket 6.
2) Bore the holes with a 6 mm drill.
3) Insert the dowels into the drill holes.
4) Position both openings of the wall-holder 6 over the drill holes and then fi x
it tightly using both screws.
RISK OF ELECTRIC SHOCK!
► Before you clean the hand blender, unplug the appliance from the power
socket.
Under no circumstances may the motor unit 4 be cleaned by immersing
►
it in water or holding it under running water.
WARNING - RISK OF PHYSICAL INJURY!
► Handle the extremely sharp blade with caution, it can cause injuries.
WARNING - PROPERTY DAMAGE!
► Do not clean the attachments of your hand blender in the dishwasher, as it
may cause damage to them.
► Do not use aggressive, chemical or abrasive cleaning agents! They could
irreparably damage the upper surfaces!
EDS-SSM 600 B2