JVC D-ILA DLA-G150CLU Manuel D'instructions page 70

DLA-G150CLU&CLE_Eng.book Page 68 Thursday, February 21, 2002 2:39 PM
Warning Messages
Message
D.ZOOM
Lamp replacement
EXIT
Warning
Lamp replacement
EXIT
68
Cause
• When the DIGITAL ZOOM button
is pressed for the video signals
that cannot be zoomed (UXGA
60Hz, SXGA 60Hz.), this
message appears for a few
seconds to notify that the image
cannot be digitally zoomed.
* To forcibly clear the message,
press the EXIT button.
Displayed when the lamp control
setting is set to NORMAL MODE
• Appears every time the projector
is turned on after the lamp use
time has exceeded 900 hours and
until it reaches 1000 hours.
* The message is cleared by
pressing any button.
Displayed when the lamp control
setting is set to NORMAL MODE
• When the lamp use time reaches
1000 hours, the word "Warning"
blinks on the screen.
* To cancel this message, press
the EXIT button.
However, the same message will
appear every hour.
* If the power is turned off after the
lamp use time has exceeded
1000 hours, the power can not be
turned on again.
* When the lamp use time reaches
1010 hours, the projector is
forcibly turned off and can not be
turned back on again.
DLA-G150CLU / LCT1123-001B / ENGLISH
Corrective action
• Digital-zoom function does not
work for the inputted video
signals.
To use the this function, input the
video signals that can be digitally
zoomed.
• Arrange for a new lamp (lamp
unit) or replace the lamp early.
• Replace with a new lamp (lamp
unit) and reset the lamp time.
Page
13, 37
44, 46
44, 46