Connecting To Devices Which Control The Projector - JVC D-ILA DLA-G150CLU Manuel D'instructions

DLA-G150CLU&CLE_Eng.book Page 27 Thursday, February 21, 2002 2:39 PM

Connecting to Devices which Control the Projector

Before connection, be sure to turn off both the projector and devices to be connected.
• Read thoroughly the manual that comes with each device to be connected.
• By connecting a computer to the RS-232C terminal, you can control the projector. Also, you can make an infrared remote
sensor extension unit and connect it to the REMOTE terminal of the projector.
* Obtain connection cables as required. Use a reverse connection cable.
* For details, refer to "RS-232C external control" on page 74.
* For further details, consult your dealer or an authorized service center.
TO CONTROL
• Desktop type
• Note type
To RS-232C connector
Note
• When connecting the cable to the REMOTE terminal, refer to "How to attach the ferrite core" on page 29.
R
G
B
H
V
IN
To RS-232C connector
To RS-232C connector
RS-232C reverse
connection cable
(separately available)
DLA-G150CLU / LCT1123-001B / ENGLISH
Y
Y/C
P /B-Y
B
VIDEO
P /R-Y
R
REMOTE
IN OUT
*
Infrared remote sensor
extension unit
(Needs to be made)
* By directly connecting the OUT terminal
to the second DLA-G150CLU IN
terminal, a number of DLA-G150CLU
units can be controlled by a single
computer.
Connecting to Various Devices
27