Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SBB 501 WP SOL
C
14
15
11
10
12
21
13
17
22
19
2. Installation instructions
2.1 Standard delivery
DHW cylinder with the following accessories
packed separately:
z
Cold water inlet pipe with flat packing
z
Adhesive rosettes for connecting lines
z
DHW sensor TF 6
z
Adjustable feet
z
Fixing straps with closures
Caution: When transporting the unit to
!
its installation site we recommend that
you remove the cylinder casing (see "2.6"), to
prevent it from becoming soiled or damaged.
2.2 Layout
A B C
1
DHW outlet
2
Heat pump flow
3
Heat pump return
4
Solar flow
5
Solar return
6
DHW circulation connection (closed as
standard)
7
Sensor well for DHW sensor
8
Sensor well for DHW sensor
9
Sensor well for solar sensor
10
Fem. connection G 1
½"
for threaded
immersion heater BGC (closed as
12
1
20
5
410
Ø 560
Ø 810
for the contractor
standard)
11
Thermometer
12
Heat pump heat exchanger
13
Solar heat exchanger
14
Signal anode display element
15
Signal anode
16
Type plate
17
Inspection port
18
Cold water inlet pipe with flat packing
(in separate pack)
19
Adjustable feet
20
Plastic cover
21
Plastic casing
22
Plastic plinth trim
23
Thermal insulation section
2.3 Requirements and regulations
z
Installation, commissioning and
maintenance of this device shall only
be carried out by a qualified installer in
accordance with these instructions.
z
Correct function and operational safety
can only be guaranteed in conjunction
with the original accessories and spares
intended for this device.
z
DIN 1988 / DIN 4109.
z
Regulations of the relevant water
supply utility.
2
7
6
8
3
4
9
18
23
16
15
23
You should also note:
z
The type plate of the freestanding cylinder.
z
Specifications.
z
Water installation
– Cold water pipe material:
Steel, copper or plastic pipe systems.
– Hot water pipe material:
Copper or plastic pipe systems
Any plastic pipe system must be designed
to withstand the maximum possible
conditions (temperature and pressure) in
the event of a fault.
Energy Saving Act (ENEG)
—
The hot water pipe must be thermally
insulated.
—
The DHW temperature in the pipework is
restricted to a maximum of 60 °C through
automatic devices or other measures. This
does not apply to DHW systems that require
higher temperatures or need line lengths of
less than 5 m.
—
DHW systems shall be equipped with
automatic devices to shut down the
DHW circulation pump.
—
On freestanding cylinders with a
DHW circulation line, the DHW circulation
pump shall be controlled by installing
a time switch and, if necessary, contact
thermostats.
7, 8
9
and
4, 5 and 6
2
3
and
Publicité
Chapitres
Table des Matières
