Operating Modes; Manual Cleaning; Settings In The Menus - Oase ProfiClear Premium Notice D'emploi

- GB -
7.3

Operating modes

Description
Automatic mode:
Operating mode for normal operation.
−
Time-dependent operation
7.4

Manual cleaning

How to proceed
Clean
Press for 3 s
LED (6) is lit
−
The display indicates
−
To cancel the process: Press the button again
−
7.5

Settings in the menus

Note:
Settings can only be made in the menus when the control system is switched on. (
OFF).
7.5.1 L : Cleaning time "Cleaning"
C C L
Setting the cleaning time changes the duration of the cleaning cycle. Extend the cleaning time if the dirt
is not completely carried away by the water, for example if the drain pipes are very long or have lots of
bends, or there is a particularly large amount of sticky dirt (e.g. during spawning).
Please take into consideration that an extended cleaning time leads to increased water consumption.
The default setting of 10 s is normally sufficient (corresponds to approx. a
How to proceed
1.
Menu
Press several times until
the display.
2.
Menu
Press for 5 s until the time is indicated in
the display.
3.
Menu
Press several times to change the
value.
To change the value quickly: Hold down the
−
button
56
Information
The display indicates the water temperature as standard.
−
A cleaning cycle is automatically started if the level detection device
−
signals an excessive deviation in the water level.
Gravity fed system: The level goes under a certain water level.
Pump fed system: The level exceeds a certain water level.
After 20 automatic cleaning cycles, a cleaning cycle with extended
−
cleaning time is performed.
In addition to the automatic cleaning cycle (dependent upon the water
−
level in the drum filter), a time-dependent cleaning cycle can be performed.
(→
The duration of the cleaning cycle corresponds to the time set in the
−
cleaning time "Cleaning" menu. (→
Information
−
C C L L
−
Information
l appears in
C
C l
−
−
−
−
−
−
−
n : Time-dependent cleaning "Interval")
I I n
The drum motor is stopped for safety reasons if the filter cover is lifted.
The rinsing pump can still be manually started to check the function of the
nozzles.
Each active cleaning cycle (automatic, time-dependent or manual) can be
stopped by pressing the button.
To cancel and exit the menu: Either wait for 10 s or press
To cancel and exit the menu: Either wait for 5 s or press
Settable range: 10 – 30 s
Increment: 1 s
The number can only be changed upwards. Once the value 30 is reached,
the display returns to 10.
Saving the set value: Wait for 5 s until the menu is automatically exited.
Cancel without saving and exit the menu: Press
L : Cleaning time "Cleaning")
C
C L
Switching ON /
7
/ drum rotation).
8
On|Off
or
On|Off
Clean
or
On|Off
Clean
or .
Clean
.
.