Electrical Connections; Water Connections - Franke medi-Flo HWSS2321W Mode D'emploi

EN

ELECTRICAL CONNECTIONS

6
Check local codes for compliance prior to making any electrical connections.
The water tight fittings have an alignment feature. Gently push the fittings together rotating until
they engage. Little to no force should be required to do so. Once fitted together, lock together by
threading the locking rings.
The connections are colour coded.
a) Connect the blue banded wires together (ozone generator)
b) Connect the yellow banded wires together (IR sensor)
c) Connect the red banded wires together (water LED)
d) Plug in the transformer to the black wire and plug into the GFI receptacle.

WATER CONNECTIONS

7
a. Connect the supply line (pre-mixed or via thermostatic mixing valve) to the ½" MIP thread
inlet (right side) of the solenoid valve.
b. Take the supplied 3/8" tube and insert it into the output side (left) of the solenoid valve.
Insert the other in the supplied shut off valve.
c. Insert the other side into the bottom of the laminar flow chamber.
d. If using a thermostatic mixing valve (Franke MIX-LF sold separately), recommended
temperature is 27-35 ∘ C (80-95 F) (Hot or warmer water is both harsher on the user's skin
and secondly, as water temperature increases, it loses its ability to dissolve ozone which
can cause reductions in sanitization performance.) When adjusting the thermostatic mixing
valve, set to minimum and verify water temperature is within recommended range.
06/17 HWSS2321W-00 | 2030030464
HWSS2321W-00
Trap
provided by others
6