Franke medi-Flo HWSS2321W Mode D'emploi page 3

EN
2
32 13/16 [833 mm]
Once solenoid/shroud mount is installed on the wall, assemble SLNA1 components
2
(found in the accessories box) as shown below. Take note of the water flow direction.
The threaded piece assembles to the input side. The 3/8 tube connector with red flow
control plug assembles to the output side.
Water Out
06/17 HWSS2321W-00 | 2030030464
HWSS2321W-00
WALL OPENINGS LAYOUT
7 [178 mm]
3 1/2 [89 mm]
2 [51 mm]
3 1/4 [83 mm]
31 9/16 [801 mm]
19 1/4 [489 mm]
FINISHED FLOOR
Direction of water flow
10 3/8 [268 mm]
Opening for rough in box
GFI Plug
Location
3 7/8 [98 mm]
1 1/2" Waste Location
Water In
8 11/16 [220 mm]
21 1/4 [539 mm]
17 5/8 [448 mm]
3