Descaling Procedure - Franke medi-Flo HWSS2321W Mode D'emploi

EN
PROBLEM
Water is not shutting off.
Water flows without activating
sensor.
11
USE AND CARE
The Medi-flo sink is made from Mirant; an artificial stone material with a premium gel coat. Avoid
the use of strong acids, paint removing compounds and abrasives.
12

DESCALING PROCEDURE

The ozone generator is an electrolytic cell which requires periodic maintenance to clean hard
water residue. The frequency of maintenance is variable depending on local water conditions
and usage. We recommend monthly inspections of the ozone generator until your site specific
frequency is determined.
Without proper maintenance, the output of the ozone generator will decrease and can eventually
lead to a no output situation as well as a potential to short out the generator rendering the
warranty void. Franke assumes no responsibility for ozone generators that are not properly
installed or maintained.
This descaling procedure normally takes approximately 10-15 minutes but can be reduced to
around 5 minutes by simply replacing the ozone generator cathode (part# MEDI-105630) with a
clean spare rather than cleaning at the sink location.
1
Remove the shroud and set aside.
There are 2 mounting locations for the shroud,
one is underneath the front lip, the other is
at the very bottom of the shroud close to the
wall.
2
Unplug power supply from the wall or
PCB controller connection.
06/17 HWSS2321W-00 | 2030030464
HWSS2321W-00
POSSIBLE CAUSES
Water droplets or debris or hard water marks/stains are
covering oval sensor window. Ensure this area is clean and
free of debris or stains.
Water will automatically trigger 20 seconds after last use for
a post-wash rinse. Water will also automatically trigger during
trap disinfection cycles. These are intentional activations
programmed for optimum hygiene.
3
3/8" tubing connection.
4
the supply side.
Close the shut off valve within the
Disconnect the shut off valve tubing at
9