DeWalt D28112 Guide D'utilisation page 10

All manuals and user guides at all-guides.com
4-1/2" (114.3 mm) Grinding Wheels
Type 27 guard
backing flange
Type 27 hubbed wheel
Type 27 depressed
center wheel
threaded clamp nut
ATTACHING SIDE HANDLE (FIG. 2)
The side handle (E) can be fitted to either
side of the gear case in the threaded
holes, as shown. Before using the tool,
check that the handle is tightened se cure-
ly. Use a wrench to firmly tighten the side
handle.
Type 27 guard
Rotating the Gear Case (Fig. 3)
1. Remove guard and flanges from tool.
2. Remove the four corner screws attaching the gear case to motor
housing.
FIG. 2
3. Separating the gear case from motor housing not more than 1/4"
E
(6.35 mm) rotate the gear case head to desired position.
NOTE: If the gear case and motor housing
become separated by more than 1/4"
(6.35 mm), the tool must be serviced and
re-assembled by a D
Failure to have the tool serviced may cause
brush, motor and bearing failure.
9
Wire Wheels
Type 27 guard Type 27 guard
3" (76.2 mm)
4" (101.6 mm)
wire cup brush
wire wheel
FIG. 3
WALT service center.
E
90˚
90˚