Correct Usage - Toshiba MMD-AP0481HFE Manuel Du Propriétaire

CORRECT USAGE

When you use the air conditioner for the first time or when you change SET DATA value, follow the procedure
below.
From the next time, the operation will start as set state by pushing the
Preparation
Turn on the main power switch and/or the leakage breaker.
• When the power supply is turned on, display section is displayed on the remote controller.
After the power supply is turned on, the remote controller does not accept an operation for approx. 1
*
minute, but it is not a failure.
• While using the air conditioner, operate it only with
switch and the leakage breaker.
• When starting the operation after stop for a long time, turn on the main power switch for 12 hours or
more before start. (This is required to turn on the compressor case heater for warming in order to
prevent overload on the compressor when activating the outdoor unit.)
3
1
ON / OFF
Push button.
The operation lamp goes on, and the operation starts.
• After HEAT operation stopped, FAN operation may continue for approx. 30 seconds.
2
Select an operation mode with the "MODE
One push of the button, in each time the display
changes in the order shown on the right.
• In the defrost mode, the fan stops so that cool air is not
discharged and PRE-DEF
3
Determine the set up temperature by
pushing the "TEMP.
button.
4
Stop
ON / OFF
Push button.
The operation lamp goes off, and the operation stops.
All manuals and user guides at all-guides.com
REQUIREMENT
ON / OFF
TEMP.
TIMER SET
TIME SWING/FIX
FILTER
RESET TEST SET CL
MODE
is displayed.
" or "TEMP. "
6
ON / OFF
button.
button without turning off the main power
ON / OFF
FAN MODE
VENT
UNIT
" button.
HEAT COOL
Operation mode
Setting range
COOL
16 to 27°C
HEAT
1
2
FAN
At shipment
from factory
18°C
25°C